IndyGo reports success with Allison Transmission eGen Flex hybrid in Gillig buses

Image credit: Allison Transmission

IndyGo has successfully operated three buses equipped with Allison Transmission eGen Flex hybrid system. The first two eGen Flex-equipped vehicles, Gillig BRT 40-ft. low-floor buses with Cummins B6.7 diesel engines, entered service in late August 2022, with the third commencing operations in mid-December.

The eGen Flex is designed to allow the vehicle to operate in full electric (EV) mode up to 50% of the time, depending on duty cycle. The system incorporates geofencing technology to automatically switch the vehicle from conventional to electric-only operation. This allows transit authorities to mark dense pedestrian areas such as city centers and bus depots as zero-emission zones; when an bus enters that zone, it goes into engine-off mode and is driven through the Rechargeable Energy Storage System (RESS).

Over their first eight months, the buses have accumulated more than 110,000 operating miles over an east-west route in the downtown area of Indianapolis International Airport. The buses have operated in engine-off, full EV mode for nearly 25,500 miles and the percentage of EV operation, not counting start-stop events, has ranged from 19-40%.

The eGen Flex system was developed from Allison’s H 40 EP hybrid system, with following features:

  • Fuel economy up to 25%;
  • Regenerative braking;
  • Lithium-titanate (LTO) battery for faster charging and delivery of up to 50 continuous minutes – or approximately 10 miles – of engine-off operation. The LTO battery has a rated life of eight years;
  • Disconnect clutch to provide seamless uncoupling from the engine drive shaft, allowing the integral electric motors to take over after the driveshaft is disengaged and the engine is shut down.
  • Dual Traction inverter that is 50 lb. lighter and one-third the size of the H 40 EP version and incorporates new switching modules with longer service life and improved system efficiency.

Source: IndyGo